GESTETNER DSM 730 DRIVER

The total rotation time is 30 seconds. Do not spill developer on the gears or sponges. Make 5 sample copies. Release the front tab [C]. While continuing to turn the black gear, slowly move the pack left and right and pour the remaining half of the developer over the augur until the developer is level. See Note in Bold Green above.
Uploader: JoJogor
Date Added: 7 May 2009
File Size: 40.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 52902
Price: Free* [*Free Regsitration Required]





If you replaced PCU components: Remove the top part [C] x1. Wipe with a dry cloth after cleaning with the cotton.

Gestetner Downloads - DSm

While turning the black gear [K], slowly move the pack left and right and pour half of the developer over the auger [L]. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6. Install the PCU in the machine. You must be logged in to post a comment. Release the front and rear springs [C]. Remove the rear cover [B] x3, Coupling x1.

Photoconductor Unit PCU 1. Remove the front screw [A] x1 5.

Open and close the door two more times. Tighten the lower screw [E].

After the machine turns the development roller for gsetetner seconds, go to the next step. Replace the cleaning blade [A] x2 Reinstallation: Release the front tab [C].

Make sure that the holes for the screws on the front and rear 7330 of the PCU are aligned correctly. Attach the front frame pawls and front and rear [A]. Turn on the main power switch. Attach the side screw [G]. Remove the development roller [H] from the development unit.

Separate the top and bottom parts of the PCU. Tighten the top screw [F].

Gestetner DSm730 Consumables

Assemble the PCU and install it in the machine. Replace the drum [E] White clip x1 [F].

I will warn you that it will most likely get messy. Leave a Reply Cancel reply You must be logged in to post a comment. While continuing to turn the black gear, slowly move the pack left and right and pour the remaining half of the developer over the augur until the developer is level. The drum unit is photo conductive. Therefore, I recommend installing the new drum unit in the machine right before you put the two halves back together.

Turn the gears [G] to remove the developer from the bottom half. Remove the rear shoulder screw [B] x1.

Therefore, I would recommend cleaning off a desk or work area ahead of time, organize your partsthen remove the PCU unit and take it over to the area where you will be working. The total rotation time is 30 seconds.

Comments

Popular posts from this blog

EGALAX WINDOWS DRIVER DOWNLOAD

AMBIT USB CABLE MODEM WINDOWS DRIVER

BLUETAKE BW100 DRIVER